Profile with reliefs
The flexibility of the belt will not be affected if the appropriate reliefs are designed into the profiles.
Profile with inserts
For special applications, profiles can be manufactured with moulded inserts. Standard inserts can be drilled, tapped and threaded in a wide variety of sizes. Customers who wish to supply inserts must supply an additional 5% to allow for sample batches. Please contact our Technical Department to ensure that the correct inserts are supplied. In the majority of cases, profile are positioned directly over a tooth, (i.e. the profile pitch is exactly divisible by the belt pitch). A pitch error between the profiles and belt is thus avoided as each profile is positioned relative to the belt teeth rather than being indexed from the last profile, which causes any errors in profile positioning to accumulate along the belt length.
Profile with drilled holes
Holes can be drilled into profiles to suit special attachments. Standard tolerances as shown, below.
Note: the profiles are drilled before they are welded to the belt
Profiles in pairs are preferred for conveying when positioning or depositing is required. Standard tolerance between profile
pairs is +/- 0.5mm. A tolerance of ± 0.2mm is attainable with special tooling. There is a tooling charge for his service.
Flash occurs between the profile and the back of the belt as a result of the welding process employed. (See Fig.2 right) The flash radius can be between 0.5 and 1mm. If the flash will impair the function of the profile, please order profiles “with flash removed”.
A drawing of the profiled belt is preferred when ordering, although a profile belt can be ordered by description alone