BAT15 BRECOFLEX®
Polyurethane, Steel reinforced, extruded truly endless, revolutionary curved tooth design, reduced noise, vibration and polygonal effect
BRECOFLEX® timing belts BAT15
- Polyurethane, Steel reinforced, truly endless
- Revolutionary curved tooth design, reduced noise, vibration and polygonal effect*
Available endless lengths for T5
- For preferred lengths refer to table below
- Over 1,500mm belts lengths available in multiples of 1 tooth*
- Over 21,990mm please enquire
Please Note: *Minimum quantities may apply
Standard lengths (mm)/Number of teeth |
---|
Length | No. teeth | Length | No. teeth |
1500 | 100 | 3750 | 250 |
---|---|---|---|
1590 | 106 | 4005 | 267 |
1710 | 114 | 4500 | 300 |
1800 | 120 | 4995 | 333 |
1905 | 127 | 5295 | 353 |
1995 | 133 | 5585 | 373 |
2250 | 150 | 6000 | 400 |
2505 | 167 | 6300 | 420 |
2790 | 186 | 6705 | 447 |
3000 | 200 | 7095 | 473 |
3495 | 233 | 7500 | 500 |
Technical Specification
BAT15 – Allowable tensile load by belt width | ||||||
---|---|---|---|---|---|---|
Belt width | b (mm) | 50 | 75 | 100 | ||
Tension member loadings | Fadm(N) | 10400 | 16000 | 21600 | ||
Belt weight | kg/m | 0.420 | 0.629 | 0.836 |
Belt widths (mm) Intermediate belt widths on request | ||
---|---|---|
50 | 75 | 100 |
BAT15 BFX | Available lengths & versions | |
Standard lengths | See table on the left | |
---|---|---|
Any number of teeth available from | 1,500mm up to 21,990mm | |
Intermediate lengths | From 1,500mm | o |
Standard Plus version | 1,500mm up to 21,990mm | |
Over 21,990mm | On request | |
Standard material | TPUST11) | |
Steel tension member (standard) | x | |
E tension member (standard) | o | |
Stainless Steel tension member | o | |
PAZ | x | |
DL/DL-PAZ | – | |
DR/DR-PAZ | – | |
T/T-PAZ | – |
x Available, standard lengths (see table) without minimum purchase
o Minimum purchase amount on request
– Not available
1) Further materials on request
Drive Type A
Type A | BAT15 | |
---|---|---|
Zmin | 20 | |
dmin | 100 |
Drive Type B
Type B | BAT15 | |
---|---|---|
Zmin | 30 | |
dmin | 150 |
Zmin = Minimum number of teeth. dmin= Minimum diameter (mm)