SFAT15 BRECOFLEX®
Polyurethane, Steel reinforced, extruded truly endless, self tracking with staggered teeth
BRECOFLEX® timing belts SFAT15
- Polyurethane, Steel reinforced, extruded endless
- Self-tracking with staggered teeth
Available endless lengths for SFAT15:
- For preferred lengths refer to table
- Over 1,500mm belts lengths available in multiples of 1 tooth*
- Over 21,990mm please enquire
Please note: *Minimum quantities may apply
| Standard lengths (mm)/Number of teeth |
|---|
| Length | No. teeth | Length | No. teeth |
|---|---|---|---|
| 1500 | 100 | 3750 | 250 |
| 1590 | 106 | 4005 | 267 |
| 1710 | 114 | 4500 | 300 |
| 1800 | 120 | 4995 | 333 |
| 1905 | 127 | 5295 | 353 |
| 1995 | 133 | 5595 | 373 |
| 2250 | 150 | 6000 | 400 |
| 2505 | 167 | 6300 | 420 |
| 2790 | 186 | 6705 | 447 |
| 3000 | 233 | 7095 | 473 |
| 3495 | 233 | 7500 | 500 |
Technical Specification
| SFAT 15 – Allowable tensile load by belt width | ||||||
|---|---|---|---|---|---|---|
| Belt width | b (mm) | 50 | 75 | 100 | ||
| Tension member loadings |
Fadm(N) | 10000 | 15600 | 21200 | ||
| Belt weight | kg/m | 0.440 | 0.660 | 0.875 | ||
| Belt widths (mm) Intermediate belt widths on request | ||
|---|---|---|
| 50 | 75 | 100 |
| SFAT15 BFX | Available lengths & versions | |
|---|---|---|
| Standard lengths | See table on the left | |
| Any number of teeth available from | 1,500mm up to 21,990mm | |
| Intermediate lengths | From 1,500 | o |
| Standard Plus version | 1,500mm up to 21,990mm | |
| Over 21,990mm | On request | |
| Standard material | TPUST11) | |
| Steel tension member (standard) | x | |
| E tension member (standard) | o | |
| Stainless Steel tension member | o | |
| PAZ | x | |
| DL/DL-PAZ | – | |
| DR/DR-PAZ | – | |
| T/T-PAZ | – | |
x Available, standard lengths (see table) without minimum purchase
o Minimum purchase amount on request
– Not available
1) Further materials on request
Drive Type A
| Type A | SFAT15 | |
|---|---|---|
| Zmin | 20 | |
| dmin | 100 | |
 |
||
Drive Type B
| Type B | SFAT15 | |
|---|---|---|
| Zmin | 25 | |
| dmin | 100 | |
 |
||
Zmin = Minimum number of teeth. dmin= Minimum diameter (mm)
